Installing and Calibrating the Ring Roamer Touchscreen

Step-by-Step Instructions

1. Clean the iPad screen using a microfiber cloth to ensure there are no debris particles present.
2. Orient the iPad correctly:
   • Ensure the camera is positioned at the top.
   • Ensure the charging port is at the bottom.
3. Install the iPad:
   • Place the iPad into the Ring Roamer, ensuring it is properly seated and lies flat against the glass surface.
4. Prepare the back cover:
   • Locate the provided USB-C charging cable.
   • Connect the charging cable to the iPad.
   • Tuck the cable carefully to avoid pinching when closing the cover.
5. Reattach the back cover:
   • Align the standoff with the screw holes.
   • Install the screws, but only halfway at first.
   • Once all screws are in, fully tighten them, ensuring they are hand-tightened without over-tightening.
6. Calibrate the touchscreen (if necessary):
   • Locate the spring-loaded pressure points designed to prevent screen damage.
   • Use the provided Allen wrench to adjust the set screw pins:
     • Turn counterclockwise to loosen.
     • Slowly tighten clockwise until the spring lifts slightly.
   • Repeat the process for all six pressure point spots.
   • Note: There is an additional hidden pressure point in the middle, but it typically does not require adjustment.
7. Test the touchscreen:
   • Touch each corner icon to ensure it responds correctly.
   • If any area is unresponsive, locate the nearest pressure point screw pin and tighten it as needed.

Important Notes

• When you received the Ring Roamer, the touchscreen was pre-calibrated. Only recalibrate if you experience issues such as dead spots.
• Avoid over-tightening screws, as this can damage components.

If you have further questions or require additional support, please contact our customer service team.

Thank you for using the Sapphire Ring Roamer!