How to assemble Helio Flare

Step-by-Step Instructions

1. Unpack the Components:
   • Open the case and ensure the following items are included:
     • Base plate
     • Side mount printer shelf
     • Head unit
     • Camera flash (if DSLR version was purchased)
     • Top and bottom columns
2. Attach the Bottom Column:
   • If using a printer, attach the bottom column to the farthest slot on the base plate (off-center).
   • Align the column with the base plate and tighten the two thumb screws until snug.
3. Attach the Top Column:
   • Clear any wires that could be pinched.
   • Align the top column with the bottom column and secure it using the alignment tabs and latches on both sides.
4. Mount the Head Unit:
   • Slide the head unit onto the top column.
   • Secure it with the black thumb screws by turning them clockwise.
5. Install the Printer Shelf:
   • Mount the support bracket to the bottom slot hole.
   • Attach the printer shelf to the upper slot hole.
   • Loosen the wing nuts, adjust the shelf, and then tighten the wing nuts.
6. Connect the Cables:
   • Connect the DC power cable.
   • Attach the female USB-A extension port to the male USB-A.
   • If using the LED column model, use the LED remote to control the front light.
   • If using a battery, insert it into the built-in compartment and connect it to the output port of the battery.
   • Run the cables through the column for a clean look.
7. Connect the Power:
   • Plug the AC power cord from the top column into the power strip below.
   • Plug the printer into the booth outlet and connect the USB printer cable to the Printio USB.
8. Test the Setup:
   • Open a browser and go to “Printio.dolo” to verify the printer connection.
   • Perform a test print to ensure everything is functioning properly.

Once your Flare Photo Booth is fully set up, you’re ready to start capturing memories. If you have any questions, feel free to contact us.