How to install iPad into E1000
How to Insert Your iPad into the E1000 Photo Booth
Step 1: Loosen the Center Screw
Insert a screwdriver through the middle of the handle and loosen the screw.
Step 2: Remove the Back Plate
Once the screw is loosened, remove the back plate from the photo booth.
Step 3: Loosen the Wing Nuts
Loosen and remove the wing nuts from all four corners of the bracket.
Step 4: Remove the Bracket
After removing the wing nuts, lift the bracket out of place.
Step 5: Position the iPad
Place the iPad on the faceplate, ensuring the charging port is at the bottom and the front camera aligns with the cutout.
Step 6: Route the Charging Cable
Route the USB-C or Lightning cable through the bottom bracket before laying the iPad flat.
Step 7: Plug in the Charger
Plug the charging cable into the iPad before placing it flat.
Step 8: Align the iPad
Ensure the iPad is centered properly, not too close to the top or bottom.
Step 9: Reattach the Bracket
Place the bracket back over the iPad and align it with the screw holes.
Step 10: Secure the Wing Nuts
Reattach and tighten all four wing nuts to secure the bracket.
Step 11: Close the Back Plate
Before closing, tuck in any loose wires to prevent pinching. Then, align and secure the back plate.
Step 12: Final Adjustments
Wiggle the back plate to ensure it’s secure. Check the front to make sure the iPad is properly aligned.
Step 13: Tighten the Center Screw
Insert the screw through the middle and tighten until snug.
Step 14: Ready to Use
Your iPad is now securely installed in the E1000 photo booth. Place it on the stand and start using it!