How to install iPad to Sapphire Ring Roamer

Step-by-Step Instructions

1. Begin by removing the black screws:
   • Locate the screws around the edges of the Sapphire Ring Roamer.
   • Use the provided tool to unscrew and remove all the screws.
2. After removing the screws, gently pop off the cover.
3. Insert your iPad into the designated area inside the Ring Roamer.
4. Press down on all corners of the iPad to ensure it is securely in place.
5. Connect the iPad to the power cable:
   • Plug the power cable into the iPad.
   • Tuck the cable into the corner for neatness and functionality.
6. Reattach the cover:
   • Align the metal screws with the corresponding holes.
   • Secure the cover by reinserting and lightly tightening the screws.
7. Once all screws are in place, ensure the glass screen is correctly pressing against the iPad:
   • Use the provided Allen wrench to tighten the screws at the corners.
   • Be careful not to overtighten—tighten just until you feel resistance.
   • Don’t forget to tighten the screw in the middle for proper contact.
8. If you experience issues with the touchscreen:
   • Loosen and retighten the screws slightly.
   • Remove the iPad, reseat it, and repeat the process.

Important Notes

• Ensure all screws are securely tightened, but avoid over-tightening to prevent damage.
• Check that the glass screen has no gaps or “dead spots” by confirming it touches all corners of the iPad evenly.
• If problems persist, double-check the iPad’s placement and repeat the setup process.

You’re now ready to use your Sapphire Ring Roamer. For any questions or further assistance, feel free to contact us!