Follow this step-by-step visual and written guide to assemble your Ring Roamer Stand. This newly designed modular system is built for quick setup and stability.
Parts Checklist
- (2) Self-leveling cross plates (base)
- (1) Lower column (with bottom thread)
- (1) Upper column (with tiltable bracket)
- (1) Ring Roamer head unit
- (1) Tightening tool (inside battery compartment)
Assembly Instructions
1. Base Plate Setup
Position the two base plates in a cross formation on a level surface.
2. Install Lower Column
Take the column section with the bottom thread. Align it with the base notches and tighten it from the inside until it is perfectly snug against the plates.
3. Connect Upper Column
Screw the upper column (the one with the tilt head) onto the thread of the lower column. Rotate until the connection is tight and seamless.
4. Attach the Head Unit
Tilt the top bracket forward. Slide your Ring Roamer head unit glides onto the bracket until fully secured. You can then tilt the unit back to your desired angle.
5. Power & Final Tension
Feed the power cable through the slot into the battery compartment. Use the included adjustment tool (found in the compartment) to tighten or loosen the tilt tension as needed.
